Programmable total loss ignitions allow precise control of timing curve and RPM limit. New digital electronics and waterproof housing provide reliable operation. Powerful multiple sparks ensure complete combustion and will even fire a fouled plug. Kits come complete with digital ignition unit, lightweight flywheel, trigger plate, trigger pick-up, ignition coil, and helicore sparkplug wires. IJSBA Superstock legal.
$1882.65
MSD Total Loss Ignition
The Enhancer for the Kawasaki® 750 features the increased spark energy you expect from MSD plus they have an adjustable rev limiter and holeshot rpm limit. The rev limit is adjusted with a potentiometer on the back of the ignition housing. The holeshot feature lets you activate a lower rpm limit that is best to use for quick starts at the beginning of a race. Also, this ignition can be connected to the factory overheat sensor. With this feature, if the water temperature gets too high, the Enhancer will limit the rpm to a safe value to avoid any engine damage. Note: Enhancer will not work on 1996 Zxi
$418.35
MSD KAW 750 ENHANCER
If you own a Yamaha with a 650 or 701 engine, this Enhancer is a necessity! The Enhancer produces a powerful spark with increased spark duration. Not only does the improved spark energy boost power, but this Enhancer features a more aggressive timing curve for even more power to get you going! At lower rpm you’ll notice incredible acceleration and throttle response due to advancing the timing. Then as the rpm increases, the timing is retarded to the factory setting to prevent detonation and engine damage. For racers, there is also a lower rpm limit that you can activate for quick and consistent holeshots. By activating a switch mounted on the handlebar the rpm will limit at approximately 3,000 rpm. The instant the button is released, the rpm revs up just as normal and you rocket off. Everything you need to install the Yamaha Enhancer is supplied along with factory connectors for a direct plug-in installation!
$387.00
MSD ENHANCER Y650/701
The Enhancer Ignition for the SEA-DOO® 800 (also the ’95, ’96, XP and GSX) uses a high speed RISC microprocessor to control all of the timing and rev limiter functions. This opens the door for programming, giving you the ability to set two rev limits and a timing curve through a series of dip switches built into the Enhancer. Being able to control the ignition curve lets you match the timing specifically to your engine and its modifications. The Digital Enhancer produces a series of sparks through 3,000 rpm rather than just a single spark. This feature delivers incredible throttle response, acceleration and keeps the idle clean and smooth. Each spark is packed with 105 millijoules of energy and up to 36,000 volts to ensure complete combustion and great performance. All of this power and features are packed into one compact housing that fits in the stock electrical box and plugs directly into your SEA-DOO’s factory wiring!
$575.30
MSD SEA DOO ENHANCER
Output voltage - 30KV, Internal windings encased in epoxy, Universal applications, Supplied with grounding wire, Used on Multi-Channel Ignitions. Depending on your application, you’ll have two, three or four of these coils. This Coil is specially designed with a higher turns ratio that is matched to the MSD’s CD output. The result is a high voltage spark that is capable of full output through high racing rpm.
$125.50
MSD SINGLE TOWER COIL
Replace your old factory coil with this direct bolt-in coil.
$176.35
MSD STOCK IMPROVED COIL
Trigger Pickup Plates are only applicable with the Multi-Channel Ignition
$132.70
MSD Y650/701 TRIGGER PICKUP PLATE
This Wand Trigger Pickup can be used for Kawasaki® SEA-DOO® and Yamaha® 650/ 701/ 760. This Trigger Pickup is only applicable with the Multi-Channel Ignitions
$73.20
MSD UNIVERSAL PICKUP TRIGGER
Perma-Seal terminals and splices provide a rugged, environmentally sealed connection for wire sizes 8 to 22 AWG that will insulate, seal and protect joints from physical abuse and abrasion, water, salt and other corrosive compounds
$121.30
PERMA SEALCONNECTION KIT
2 pin MSD waterproof connector
$8.05
2 PIN MSD WATERPROOF CONNECTOR
4 pin MSD Deutsch Connector
$17.36
4 PIN MSD DEUTSCH CONECTOR
Is your electrical box mounted in a place that you can not easlily remove it in case of an emergency and quilkly replace it with another elctrical box if you were having problems? Then we have the answere, Bullett Racing's exclusive ULTRA/STXR electrical box holder for SXR. This is the cleanest way to mount your electrical box and have easy access.
$299.99
Bullett Racing elec box holder
